Products Category
News Center
Contact Us
Name: Maggie
Tel: 0086-13714590845
Mobile: 0086-13714590845
E-mail: nextdiag@gmail.com
Add: 201, No.45 Building, 3rd Part, Zhangkeng, Minzhi,Baoan, Shenzhen, Guangdong,China
Tel: 0086-13714590845
Mobile: 0086-13714590845
E-mail: nextdiag@gmail.com
Add: 201, No.45 Building, 3rd Part, Zhangkeng, Minzhi,Baoan, Shenzhen, Guangdong,China
Universal 5.5'' A8 Car HUD Head Up Display OBD2 GPS speedometer |
|
|
|
Product name:Universal 5.5'' A8 Car HUD Head Up Display OBD2 GPS speedometer |
|
Item:H00-011 |
|
Details: |
|
HUD installation procedure: Ensure your vehicle is OBDII compatible or EUOBD.
Check around the area under the steering wheel for an OBD plug
Contact your vehicle manufacturer or search online
Open the bonnet and look for a OBDII compatible sticker (this is NOT on all OBDII compatible cars, therefore isn’'t a deciding factor)
Locate the 16 pin diagnostic link. This is usually located in the area under the steering wheel.
Start vehicle's engine and ensure power switch is in the on position.
HUD will power on with engine
If the HUD displays vehicle voltage, fuel consumption, speed and rotational speed the unit has installed correctly.
Failing the above: Wait up to one minute for software to sync and confirm OBD cable is plugged in properly.
Reflective film installation
Using the unit without the reflective film may result in a double image observed by the user depending on the windshield. If you see a double layer it is due to the windshields dual layer construction and you should install the film by following the instructions below.
Place the supplied non-slip mat in the desired position on the dashboard with the HUD on top.
Observing where the HUD reflects place the reflective film in position.
Ensure the surface is clean and dry before installing the film;
Remove the back protective side marked (1) and attach the film to the clean windscreen;
Once you're satisfied with the location use a credit card or similar to remove any bubbles or air pockets that remain;
Remove the front side marked (2), if you need to adjust the HUD's reflection, reposition using the nonslip mat
Note:
1. OBD2 / OBDII interface HUD:
a. Suitable for Europe and North America cars, it can only be applied to Vehicles with OBD2 interface manufactured after 2003. For Asia, it can be used to cars with OBD2 interface manufactured after 2007
b. Do not support cars with OBD I and JOBD interface (Japanese OBD)
2. GPS HUD:
GPS car HUD supports all cars (When you have no idea about the date interface of your car, you can choose the GPS HUD) |
|
←[Previous:H00-012] [Next:H00-06]→ |
Related Products : |